Connect to a modified router
This will explain how to connect to the serial ports on a modified LinkSys WRT54G using serial communication software such as the open source Kermit.
Expose a serial port on the router
You must have successfully modified a LinkSys WRT54G to expose at least its first serial port in such a way that you can connect it to another machine with serial communications software. If you have not done so yet, please see HOWTO:Modify the Linksys hardware
Acquire serial communication software
A solid open source suite of communication software known as Kermit has served us well as a method of communicating with the WRT54G. C-Kermit, the UNIX compatible implementation, is available for download at their website .
Steps to Connect to the Router
Task One: Power up the Router
Yes, that means plug it in.
Task Two: Connect Serial (& Optionally Network) Cable(s)
Ensure that the connection is going from UART0 (the first serial port--you did label them didn't you?) as this is where the console will be running.
Also, because the goal is to upload custom code to the router, it would be a good idea to connect the router to your network by wiring it up via one of the numbered LAN ports on the back of the router (NOT the Internet/WAN port).
Task Three: Configure your Serial Communication Software
The connection used by the router's serial port is fairly standard: 115200bps, with 8 data bits, no parity bit, and 1 stop bit, or 8N1.
In our setup, once running Kermit on the external machine, we connected by typing in:
||to connect to the device talking to the router.|
||which is not really necessary since this is default.|
||as given to us in the router specifications.|
Task Four: Connect to the OpenWRT Console
In Kermit, after the configuration commands have been entered, it was as easy as typing
connect. Once connected, press
Enter to get a console from OpenWRT. This should function just about identically to the ssh console, and if it works correctly, it means that the serial port has been correctly installed.